Tuesday, September 8, 2015

You do not need to have access to the inside of the tank!

Uniseals are some of the best Pipe-ToTank seals available. In static conditions Uniseal® is good up to 65 PSI and can withstand pressure and suction, acids, oils, greases, gasoline, sewage, waste, heat and cold. It offers long life, easy installation and reduced labor and material costs.

Uniseals are designed for pipe penetrations through tanks or cisterns. They can also be used to create cross connection from one pipe to another. The great thing about Uniseals is that you do not need to have access to the inside of the tank which makes the installation process much easier than traditional bulkheads.

Perfect for:

Cisterns, Rain Barrels, Aquaculture, Hydroponics, Aquariums, Marine/RV, etc.

Handle up to 40 PSI - Fit PVC & Steel pipe.

Size range from 3/8" to 6".

25 year warranty.

Instructions for Installing UNISEAL

1. Cut hole to the Holesaw size indicated on the Uniseal Sizing Chart (see below)
   Example: 3" Uniseal = 4" Hole (Holesaw)
2. Ensure the hole is clean cut with sharp edges. Irregularities could cause poor seating and ultimately, leakeage.
3. Insert Uniseal into hole with the wide side facing the pipe to be inserted.
4. Make certain that the pipe end to be inserted is clean cut. File the edges so that there are no sharp points to cut the Uniseal.
5. Using detergent or silicone lube, lubricate the outside of the pipe end to be inserted, then push the pipe through the Uniseal from the large flange side.
   The detergent will be squeezed off as the pipe passes through the Uniseal. The co-efficient of friction of the rubber holds the pipe tightly in place.